Contact: ****[email protected] FB: Link Linkedin: Link

Profile

畢業於國立陽明交大電機所甲組，研究題目為「數位輔助高解析度類比數位轉換器之設計技巧」。 樂於助人、認真負責、喜於跨域交流，具有豐富的跨領域學習經驗。 大學就讀百川學程，主修電機及資訊工程，擁有軟硬系統結合能力。也有豐富的機器人教學及國際競賽經驗。 I graduated from the Institute of Electrical and Computer Engineering (NYCU). My research focuses on high-resolution signal converters with digital assistance techniques. I am enthusiastic about helping others, taking responsibility, and enjoying communication. I have experience in cross-disciplinary learning, having studied in Arete Honors Program during my undergraduate years, with a major in ECE & CS. I possess the ability to integrate software and hardware systems and also have rich experience in teaching robotics and participating in international competitions.

Education

• B.Eng. in Arete Honors Program @National Yang Ming Chiao Tung University                                                 09/2018 - 06/2022

  major in Electrical and Computer Engineering with Computer Science Cross-disciplinary Program GPA:4.08

• M.S. in Department of Electronics and Electrical Engineering @National Yang Ming Chiao Tung University    09/2022 - 12/2024

  Advisor: Chia-Hung Chen Lab: ADC LAB GPA:4.3

Master Projects

• A low THD+N class-D audio amplifier with digital PWM and digital loop filter 09/2023 – 12/2024
  • Design a digital modulator with a low pass filter to process input data.
  • Design a class-D audio amplifier with a digital loop filter.
• A 5th-Order Digital Delta-Sigma Modulator for High-Resolution Audio Systems 12/2021 – 12/2024
  • Realize a digital 5th-order delta-sigma modulator that converts the analog delta-sigma ADC output code from 4-bit to 1-bit.
  • Realize a cascaded integrator comb (CIC) filter to attenuate MEMS resonant frequency noise.
• Serial Peripheral Interface (SPI) for SAR ADC (40nm)                                                  01/2024 – 02/2024
  • Use SPI to adjust the analog circuit and access SAR digital output in SRAM.
• Serial Peripheral Interface (SPI) for SAR ADC (28nm) 01/2023 – 05/2023
  • Use SPI to adjust the analog circuit and access SAR digital output. Design a digital encoder to sum up SAR raw output code and store the digital code in SRAM.
• Digital Circuit of Successive-approximation (SAR) ADC (65nm) 06/2022 - 09/2023
  • Realize digital circuits in the rad-hard version of 10/12bits SAR ADC. (ITRI Research).

Undergraduate Projects

• Optimization and Improvement of the Baseball Pitching Machine 09/2019 - 06/2022
  • Remodeled the current baseball pitching machine to optimize baseball players’ training effectiveness and variability by adding an FPGA Controller (NI MyRIO) to control the pitch's trajectory and further added more features (MOST College Student Research Scholarship).
• Applied Reinforcement Learning on Tetris 03/2019 - 06/2019
  • Utilized LabVIEW to build a reinforcement learning model using the Extended Classifier System (XCS) method to play Tetris (Game).
• World Robot Olympiad (WRO), Advanced Robotics Challenge 07/2018 - 12/2018
  • Built the most stable mobile robot in the world with an FPGA Controller (NI MyRIO) and TETRIX, capable of stacking Tetris blocks randomly scattered on the ground against the wall.
  • Won 2nd place in the Advanced Robotics Challenge out of 63 countries.

Competition, Honors, and Awards

• World Robot Olympiad, Gen II Football - 5th place, 2014
• World Robot Olympiad, Gen II Football - 6th place, 2015
• World Robot Olympiad, Advanced Robotics Challenge - 2nd place, 2018
• Presidential Education Award, Strive Forward Award, 2018